Paint Booth Fire Suppression for Delaware County Shops
Paint, solvents, and overspray can turn a small spark into a booth fire in seconds. Tri-State Fire Protection Services inspects, tests, and repairs paint booth fire suppression systems for body shops and finishers across Delaware County, PA. We are a local team based in Folsom.
PAINT BOOTH FIRE SUPPRESSION
BUILT FOR BUSY SHOPS
When Was Your Paint Booth Fire System Last Checked?
In a busy body shop, the booth runs all day. Cars roll in, get painted, and roll out to bake. The fire system on the ceiling is easy to forget about, right up until the insurance inspector asks to see the tag.
A paint booth fire system only protects you if it is ready to fire.
Paint booths have a lot that can burn. Wet paint, thinners, dried overspray on the walls, and dusty filters all feed a fire. A spark from a sanding tool or a worn fan bearing can light it.
Your paint booth fire suppression system is built to stop that fire fast. Nozzles in the booth, behind the filters, and up in the exhaust duct spray a dry chemical over the fire. At the same time, the system shuts off the spray guns and the exhaust fan, so the fire is not fed or pulled up the duct.
Overspray is the catch. It coats nozzles and heat detectors over time, and that can slow them down when it counts. That is why fire code calls for a full inspection every six months.
Tri-State Fire Protection Services keeps paint booth fire suppression systems working for collision centers, body shops, cabinet and furniture finishers, and manufacturers across Delaware County. Our founder is a firefighter, and he knows how fast a booth fire can spread.
OUR SERVICES
Questions? Talk to Our Team
Call our Folsom office or request service online.
WHAT WE DO
Paint Booth Fire Suppression Inspection and Repair
From the tank on the wall to the nozzles in your exhaust duct, one team keeps your booth fire system ready. Here is what we handle.
Six-Month Inspections
Fire code calls for a paint booth fire suppression inspection every six months. We test the system, check every part, and leave you with a fresh tag and a clear report.
Nozzle and Detector Service
Overspray builds up on nozzles and heat detectors. We clean or replace caps, change the fusible links, and make sure nothing is coated over.
Shutdown Testing
When the system fires, your spray guns and exhaust fan have to shut down. We test those connections so the fire is not fed or pulled up the duct.
Recharge After Discharge
If your system goes off, the booth stays down until it is cleaned up, refilled, and reset. We get you back to painting.
Repairs and Booth Changes
New booth, new filters, or a change to your exhaust? We repair problems and adjust the system to match your setup.
Inspection Reports
You get a written report after every visit, ready for the fire marshal, your landlord, or your insurance company.
WHAT TO EXPECT
What Happens During a Paint Booth Fire Suppression Inspection
Your booth fire system gets a full check every six months. Here is what our tech does on each visit.
We look over the whole system.
The tank, the piping, the nozzles, the detectors, and the pull station.
We check every nozzle.
Each one in the booth, the plenum, and the exhaust duct should be aimed right, capped, and free of overspray.
We replace the fusible links.
Heat and paint wear them out, so we change them at every six-month visit.
We test the release.
We make sure the system will go off by itself and from the pull station.
We test the shutdowns.
When the system trips, the spray guns, paint pumps, and exhaust fan should shut off right away.
We tag it and write it up.
You get a report you can hand to the fire marshal or your insurance company.
The rules behind all of this come from NFPA 33, the national standard for spray booths, and NFPA 17, the standard for dry chemical systems. We keep up with them so you do not have to.
Overspray Tip
Never paint over or tape over nozzles, caps, or heat detectors when you clean or mask the booth. A coated detector can be slow to sense a fire. If they are getting buried in overspray between visits, call us and we will show you how to protect them the right way.
DON'T WAIT
Signs Your Paint Booth Fire System Needs Service
Most problems are easy to spot from inside the booth. Look up and around for these.
Any one of these is a good reason to call. A quick visit costs far less than a failed inspection, a denied insurance claim, or a booth fire.
The tag on your system is more than six months old.
Nozzles or heat detectors are coated in overspray.
A nozzle cap is missing.
The gauge on the tank is out of the green.
The pull station is blocked or its pin is missing.
The system went off, even partway.
You replaced the booth, the filters, or the exhaust fan.
Your insurance company asked for inspection records you can't find.
WHERE WE WORK
Paint Booth Fire Suppression in Delaware County, PA
Our shop is at 228 Ridley Avenue in Folsom, close to most of the county's body shops and industrial sites. We can work around your paint schedule and keep your booth downtime short.
Delaware County has collision and body shops on nearly every main road, from MacDade Boulevard and Chester Pike to Baltimore Pike and West Chester Pike. It also has manufacturers and finishers in the industrial areas of Aston, Chester, and Eddystone. Each one with a spray booth needs a working fire system.
We serve all of Delaware County including:
Folsom
Prospect Park
Swarthmore
Havertown
Newtown Square
Aston
Ridley Township
Springfield
Upper Darby
Lansdowne
Chester
Glen Mills
Ridley Park
Media
Drexel Hill
Broomall
Brookhaven
Middletown
Located outside of Delco? We also service paint booth fire suppression systems throughout Pennsylvania, including Philadelphia, Chester County, and Montgomery County, as well as New Jersey and Delaware.
WHY TRI-STATE
Why Delco Body Shops Call
Tri-State Fire Protection Services
Shop owners across Delaware County choose Tri-State Fire Protection Services for our fire service background, our respect for your schedule, and our one-stop service. Here is what sets our team apart.
Started by a
Firefighter
Kevin Kerns founded Tri-State in 2019 after years as a firefighter, EMT, and 911 dispatcher. He knows how fast paint and solvent fires grow.
Built Around
Your Schedule
A booth that is down is a booth that is not making money. We plan visits around your paint schedule and get in and out.
Booth and Shop,
Covered
Your booth system, fire extinguishers, emergency lights, and alarms can all be handled by one team on one schedule.
Training for Your
Painters
Our sister company, Tri-State Training, teaches your crew how to use a fire extinguisher and what to do when a fire starts.
What Our Customers Say
COMMON QUESTIONS
Paint Booth Fire Suppression Questions We Get Asked Most
These are the questions body shop owners and plant managers ask us most.
Have additional questions? Contact Tri-State Fire Protection Services today to speak with our team.
How often does a paint booth fire suppression system need to be inspected?
Every six months, by a trained technician. That is the rule in NFPA 17, and your fire marshal and insurance company will both look for the tag. If your tag is more than six months old, you are past due.
Who should I call for paint booth fire suppression service near me in Delco?
Pick a company that is close by, works on paint booth systems regularly, and will test your shutdowns, not just hang a tag. Tri-State Fire Protection Services is based in Folsom and was founded by a firefighter. Call us at (610) 707-8180 and see if we are a good fit.
What happens when a paint booth fire system goes off?
An alarm sounds, and the system shuts off the spray guns, the paint supply, and the exhaust fan. Then nozzles in the booth, behind the filters, and in the exhaust duct spray a dry chemical powder to put out the fire.
What do I do after my system goes off?
If there is a fire, get everyone out and call 911. Do not paint or run the booth again until the system is cleaned up, refilled, and reset. Then call us, and we will get your booth back in service.
Can I clean or mask over the nozzles and detectors?
No. Never paint, tape, or wrap them unless the system maker allows it. A coated nozzle or heat detector may not work in a fire. Ask us how to protect them from overspray the right way.
Do I need a new system if I replace my paint booth?
Usually, the system has to be changed to fit the new booth. A different size, layout, or exhaust setup can leave gaps in coverage. Call us before the new booth goes in.
How much does paint booth fire suppression service cost?
It depends on the size of your booth and your system. Tell us about your booth, and we will give you a quote.
Thank you for contacting us.
We’ll get back to you as soon as possible.
We got it.
GET STARTED
Get Your Paint Booth Fire Suppression System Checked
Call us or fill out the form to get started. Tell us about your booth and your paint schedule, and our team will reach out with a quote and a time that keeps your downtime short.